Active connecting box with TTL output signal, for force-measuring sensors
The active connecting box X-201-S14 interconnects two sensors and sends the average signal out as a frequency. The connecting box is simply installed between the sensors and the controller. It can be used with sensors on the yoke, or at the anchor point, or on the floor of the cabin. It is not necessary to use two sensors. In some applications acceptable results can be obtained with only one sensor.
Output devices from X-SENSORS convert sensor measurements into current-loop, voltage, frequency, LON bus, CAN bus, CAN Open, relay closures and so on. If the hardware configuration is know, the electronics can apply null-point correction for especially precise measured results. The output devices can also provide programmable slack-cable detection. Elevators: