Strain Transducer X-103-S05
especially suitable for applications with full bridge signal mV/V
For accurate measurements of the smallest strains
Strain gauge sensors without an integrated measuring amplifier are particularly suitable for applications where the full bridge signal mV/V is required or where several sensors have to be connected to one measuring amplifier. This can be the case, for example, when measuring the weight of silos and monitoring several tie bars on presses.
The strain transducers are ideally suited for use in the following areas:
- Measurement, monitoring and control of forces in forming technology
- Weight measurement on beams or supports
- Measurement of smallest strains on rigid structures for analysis of mechanical loads
X-Sensors strain transducers reliably measure even small strains on the surface of flat structures. Despite the simple screw-on mounting, the measured values are comparable to glued-on strain gauges, while avoiding their disadvantages.
Properties
- Reliable measurement of smallest strains for indirect force measurement
- 0…1000 µm/m nominal measuring range
- For cyclic and static force measurements with subsequent measurement amplifier
- Extremely flat design of only 6.5 mm height
- Simple and space-saving mounting directly on the construction surface
Compare this Product
Data sheet – Strain sensor with DMS output signal / without amplifier
STEP-Datei X-103-S05
Downloads
Data sheet – Strain sensor with DMS output signal / without amplifier STEP-Datei X-103-S05Measuring principle
How it works
The surface strain sensor X-103-S05 detects the strain between the two screw-on surfaces and amplifies it mechanically. This concentrates the strain on the measuring point, where it is converted into an electrical signal by means of a resistive measuring bridge. The solid steel housing and the tight design (IP65) guarantee problem-free operation, even under difficult environmental conditions.
Technical specifications
Details
| measuring range | |
|---|---|
| Bauform / Montage | |
| Anwendung / Tarierung | Cyclic Applications, Static Applications, Without integrated amplifier |
| Ausgangssignal | |
| Electrical connection | 1 m cable with open strands, 3 m cable with open strands, 6 m cable with open strands |
| Feature | |
| (K) Messbereich (in µm/m) | |
| (K) Input sensitivity (in mV/V) | 0.5 |
| (K) Output signal | 0.5 mV/V |
| (K) Cable length | 1.0, 10.0, 2.0, 3.0, 5.0 |
| (K) Electrical connection | M12 – 5pol. Plug, open strands |
| (K) Mounting position | Load measurement at the yoke |
Contact us!
We are happy to answer your questions about our sensors and find a solution for your application.
X-SENSORS AG
If you have any questions about our products, we are at your disposal.
Mit Erfahrung und Freude an Innovationen
